Use two 5G37 to connect to the BTL amplifier circuit . Under the same working voltage, the output power is better than the monolithic integrated circuit.
This article refers to the address: http://
When designing the circuit cable, the decoupling capacitor is preferably connected near the 8 pin, and pay attention to the layout of the ground wire. Otherwise, the integrated circuit may be damaged due to low frequency self-excitation. In addition, if there is low frequency self-excitation, it can be at both ends of the field sounder. Connect a capacitor with a capacity of 0.1UF to the ground, and remove the 0.1UF capacitor of the original 10 ohm resistor. This circuit can get more than 3W output power at 12V power supply voltage.
Draw-wire sensors of the wire sensor series measure with high linearity across the entire measuring range and are used for distance and position measurements of 100mm up to 20,000mm. Draw-wire sensors from LANDER are ideal for integration and subsequent assembly in serial OEM applications, e.g., in medical devices, lifts, conveyors and automotive engineering.
Linear Encoder,Digital Linear Encoder,Draw Wire Sensor,1500Mm Linear Encoder
Jilin Lander Intelligent Technology Co., Ltd , https://www.jllandertech.com