The basic structure and parameters of the rectifier circuit, when repairing various types of rectifier circuits in various electrical equipment, can measure its output voltage and judge whether its circuit can work normally. In a circuit with multiple rectifying elements, if one rectifying element fails, the output voltage may be lowered. As long as the output voltage value is measured, it is possible to determine whether the circuit and the rectifying element are faulty. The drawing is the basic structure of the rectifier circuit, and the attached table is the basic parameters of the rectifier circuit. 
Note: The data given in the table refers to the output DC voltage when no load is connected and the capacitor is not connected. When the load is loaded, the output voltage will drop slightly. If the output terminal is connected with a large-capacity capacitor, the no-load voltage will rise to Peak.
6.35MM Power+ Signal Power Connector
power connector is used in power module system. It can select the matching power + signal connector according to the need. The feature is that the number of power and signal contacts and the matching sequence can be selected arbitrarily while keeping the connector size and contact core number unchanged.
Plug (male) / socket (female) can be installed at 90 or 180 degrees. It supports mixed or independent combination of signal and power. The quantity range of power and signal is (2-16) pin and (12-128) pin respectively
Product features
High temperature resistant, glass fiber reinforced and flame retardant polyester is used as insulation material
Copper gold composite conductor with high conductivity is used, and the contact area of the conductor is plated with gold
It adopts shrapnel contact, which has the characteristics of integration, small volume, large current carrying capacity, soft plug-in, blind plug-in, self guidance and high dynamic contact reliability. This series of products can be interchanged with FCI's powerblade series and Tyco's multi-beam series
There are three sizes of center distance of power contact: 5.08mm, 6.35mm and 7.62mm
The length of power hole / signal pin can be selected in two sizes. The power rated current is 45A and the signal rated current is 2.5A
6.35MM Power+ Signal Power Connector
ShenZhen Antenk Electronics Co,Ltd , https://www.antenkcon.com