Causes and treatment of motor bearing overheating:
1. Bearing damage. Should be replaced.
2, rolling bearing grease is too little, too much or there are impurities such as iron filings. The capacity of the bearing grease should not exceed 70% of the total volume. Those with impurities should be replaced.
3. The shaft and bearing are too tight or too loose. When it is too tight, it should be reground. If it is too loose, it should be set to the shaft.
4. The bearing and the end cap are too tight or too loose. The bearing housing is machined when it is too tight, and the steel sleeve is placed inside the end cover when it is too loose.
5. The motor ends or bearing caps are poorly assembled. Install or flatten the end cap or bearing cap stop and tighten the screws.
6. The belt is too tight or the coupling is poorly assembled. Adjust the belt tension and correct the coupling.
7. The sliding bearing lubricant is too little, and there are impurities or oil ring stuck. Refuel, replace, repair or replace the oil ring.
Fiber Pen Nib,Passive Capacitive Stylus Pen,Rubber Tip Stylus Pen,Microsoft Stylus Pen
Shenzhen Ruidian Technology CO., Ltd , https://www.wisonens.com